I'm not sure if this have been asked before, but I'm looking to create a simple breakout board to power and boot the Edison with a DC adapter from a wallet outlet.
Is this done by simply add a voltage between 3.3 - 4.5 V to ANY (choosing one) of the VSYS pins 2, 4 or 6 AND connecting the PWRBTN# pin 17 to GND (with pushbutton ofc)? I also noticed that DCIN pin 14 should be connected to (ANY?) VSYS pin when powering from a DC adapter, is this correct?
EDIT: Most of this is described in the Hardware Guide, but I just want to make sure that I got it right! For example, if bridging the DCIN pin to VSYS there's no resistor needed, just making sure